Topic: Service Config tool

phscphsc
edited October 2006 in InfraSensing Sensors
Hey all



I Have the Serverscheck running with a Temperature Sensor on a W2003 ent. edt. server SP1



My problem is that even though I can configure the Service (with the tool) correctly, the system stops monitoring when I log of.



I have tried both to have the service run as Local System and Domain Admin but no luck.



If I run the Serverscheck program and leave it open and just disconnect my session it runs perfectly. But I was under the impression that using the service should enable me to continuously monitor via my Serverschek rules..

Comments

  • AdministratorAdministrator
    Go to the Windows Services console, make sure that the "ServersCheck Monitoring Service" is set to automatic.



    I assume that you are not referring to the Web Server. if so, then please see help file: the web server is running from a different service called the "ServersCheck Configuration Service". Make sure that this service is running if you want web access.
This discussion has been closed.