SensorGateway1 Email Alerts

SchoJoseSchoJose
edited April 2011 in InfraSensing Sensors
We are using a SensorGateway tempature/humidity sensor, and have it configured to send out email alerts via an SMTP server. We seem to never actually get the email alerts unless we reboot the sensor while it's in an alarmed state. Our sensor is networked, we have it configured via the web interface and are not using any software.



Test emails go through fine. We have tried several SMTP servers both with and without authentication standard and non-standard ports. I'm sure the configuration is correct because the emails do come through when you reboot the sensor, but we need these emails to be sent reliably.



I tried updating to the latest firmware, which sped things up, but we still have the same email issue. Any ideas?

Comments

  • [Deleted User][Deleted User]
    I have the same problem, its new product.
  • AdministratorAdministrator
    Do you have the repeat alarm option enabled or disabled? If disabled then enable it
This discussion has been closed.