SNMP OIDs needed for Smoke and Leak on MultiSensor HUB EXP-4HUB

Hardware Version
Release 5.1
Firmware Version
Release 8.6

Leak - Connected on MultiSensor & Hub "Leak" ethernet port
Smoke - Connected on MultiSensor & Hub "Input 1"

Both work via web GUI, snmpwalk only seems to dump info about the BASE-WIRED SensorGateway, not the hub attached to it, see below:

snmpwalk -v2c -t 1 -c public
SNMPv2-MIB::sysDescr.0 = STRING: Temperature & Sensor Gateway
SNMPv2-MIB::sysObjectID.0 = OID: SNMPv2-SMI::enterprises.17095
DISMAN-EVENT-MIB::sysUpTimeInstance = Timeticks: (34217334) 3 days, 23:02:53.34
SNMPv2-MIB::sysContact.0 = STRING:
SNMPv2-MIB::sysName.0 = STRING: BRD DC SensorGateway
SNMPv2-MIB::sysLocation.0 = STRING: BRD Data Center
[admin@localhost ~]$

If anyone knows the SNMP OIDs for smoke and leak it would be appreciated.


  • AdministratorAdministrator This free mib browser will perform the SNMP walk and provide you with the OIDs as those are configuration specific and not generic
  • DGwerdDGwerd
    I tried the mibbrowser, under descriptions I see different items for "smoke alarm" and "Flooding" but no actual output for these items.
    "Smoke" is set up on "Input 1" per your diagrams but the mibbrowser does not show anything for Smoke or Input 1.
  • DGwerdDGwerd
    After reloading the MIB file I do see sensor13Name/value for FLooding1 but nothing for "smoke" on "Input 1". All of the different sensor items on the MultiSensor & Hub appear - Power, Sound, Shock,Light, Motion, etc but no SNMP values or descriptions for the different generic "Inputs". Can someone provide these OIDs?
  • DGwerdDGwerd
    Now I have found the "smoke" Input1.....
    Smoke - Input1name: .
    Smoke - Input1Value: . "OK" or

    Flooding1 - sensor13Name: . "Flooding1"
    Flooding1 - sensor13value: . "WET" or "DRY"

Sign In or Register to comment.