Toggle navigation
Products
Services
Solutions
Partners
Support
About
Contact
Monitoring Software v12 and lower
VNC - changing the setting
tdansey
June 2006
edited June 2006
in
Monitoring Software v12 and lower
I need to change the port that Sc uses to run the VNC interface.
Where can I alter this setting please?
Comments
Administrator
June 2006
The VNC port to use can be defined as follows:
Go to General Settings > Configure List of Devices
Add a new device and enter the IP address and the VNC port to use.
It uses the JAVA VNC client from your VNC server. This needs to be enabled on the VNC server.
tdansey
June 2006
Thanks - I had missed the fact that it is configured in the device and not the rule.
Thanks again.
This discussion has been closed.
© 2003-2019 ServersCheck™ All rights reserved |
Sales Terms
|
Warranty Policy
|
Privacy Statement
|
Terms of Use
© 2003-2019 ServersCheck™ All rights reserved
Comments
Go to General Settings > Configure List of Devices
Add a new device and enter the IP address and the VNC port to use.
It uses the JAVA VNC client from your VNC server. This needs to be enabled on the VNC server.
Thanks again.