Sensors are not detected
One of our remote offices installed a base unit, hub, and 4 temperature sensors. Per the manual, they connected Sensor 1 on the base unit to Probe 1 on the hub, and 2 to 2. This was incorrect. The sensor leds lit continuously, but were not detected. We then realized that 1 should go to 2 and 2 to 1. The sensors now blinked as they should. The hub and its dry contact inputs were detected, but not the sensors. I shipped them two other working base units, they tested all sensors with known good cables, and connected direct to the known good base unit. None of the sensors shows up. It seems the initial configuration may have broken these sensors, though they followed the manual. What next?
This discussion has been closed.